Citizen CBM-910 Type II Manuel d'instructions télécharger pdf (Page 66)

Chapter 4 ION Measurement

54 HORIBA

・For calibration using multiple standard solutions, continuously perform from one solution

to another. If returned to the MEAS screen once, you have to go back to the 1st point

calibration.

・When an error occurs in calibration, the screen displays the error.

Remove the cause and start the calibration from the beginning.

4.3 Checking Before Use

When the preliminary check function is ON, you can check repeatability with the standard

solution of the 1st point calibration. Use this function to check measurement accuracy by

checking repeatability.

An operation guide is displayed after the 2nd point calibration is completed. Check the

repeatability according to the operation guide.

After the set point calibrations are completed, repeatability is automatically checked using

the deviation between the calibrated and measured values at the 1st point.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 113 114

Pas de commentaire

Citizen CBM-910 Type II Manuel d'instructions Page 66