Citizen PPU-700 Spécifications télécharger pdf (Page 73)

- 71 -

GS V m … (1)

GS V m n … (2)

[Function] Cutting the paper

[Code] (1)<1D>H<56>H<m>

(2)<1D>H<56>H<m><n>

[Range] (1)0≦m≦1、48≦m≦49

(2)65≦m≦66

[Outline] Performs the specified paper cutting.

m Function

0,48 Full cut

1,49 Full cut

65 Paper feed by “cut position + basic calculation pitch” and full cut

66 Paper feed by “cut position + basic calculation pitch” and full cut

[Caution] • In STANDARD MODE, this command only works when it is entered at the beginning of

a line.

• Control to make the length of cut paper less than 10 mm is not executed.

For (1):

• Executes cutting of paper.

For (2):

• If n = 0, the paper is fed to the cut position, and then cut. If n ≠0, the paper is fed

by “n×basic calculation pitch” inches past the cut position, and then cut.

• The basic calculation pitch is set by GS P.

• The paper feed amount is calculated with the vertical basic calculation pitch (y). A

fraction resulting from the calculation is corrected with the minimum pitch of the

mechanism, and the remainder is omitted.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 187 188

Pas de commentaire

Citizen PPU-700 Spécifications Page 73