Citizen CLP-631 Spécifications télécharger pdf (Page 23)

Printer Operation

Media holder bar

Media holder guide

Sensor arm

Large blue-head open lever

Head unit

2. Firstly, slide the two black plastic parts of the media holder

assembly together. Ensure correct alignment of the guide with

the bar as it can only be installed in one direction.

3. Slide the roll of media over the media bar. The media guide

must be on the right side of the roll of media (as viewed from

the front of the printer) with the flat surface of the media guide

touching the roll.

Installing the Media

1. Push the large blue-head open lever to release the head unit,

and then lift the sensor arm by hand as shown below.

Media Sizes (p.22)

Setting the Media

4. Set the media roll and media holder in to the printer as shown

above. It is advisable to pull a length of media forwards and

through the mechanism ready for later positioning.

5. Move the media roll so it is touching the leftside of the housing.

Then slide the black media guide so it is touching the media on

the right side.

Note: Do not try to hold the media too tightly with these guides as it will

cause the printer to jam during printing.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 59 60

Pas de commentaire

Citizen CLP-631 Spécifications Page 23