Citizen C390 Spécifications télécharger pdf (Page 24)

4746

4. This fully lit display is canceled when the crown is returned to the normal

position.

• After cancelling, a confirmation tone is sounded after which each of the

hands perform a demonstration movement in the order of the second hand,

minute hand, UTC minute hand, UTC hour hand, the hour hand, and the 24

hour hand to indicate that the all-reset procedure has been completed.

• After the demonstration movement, pull the crown out to the second click to

switch the setting to the watch base position setting state.

Always make sure to set the 0 position (base position) for the hour hand,

minute hand, second hand, 24-hour hand and UTC hour and minute hands

while referring to "4. Checking 0-Position of Each Hand <0-Position

Correction>".

Note:

• After setting the 0 position (base position) for each hand, correctly reset the

time, calendar and other modes before using the watch.

<All-Reset Procedure>

1. Turn the crown to set the mode hand to the chronograph [CHR] mode.

2. Pull out the crown to the second click.

• The second hand, minute hand, hour hand, 24 hour hand, UTC hour hand

and UTC minute hand rapidly advance to the 0 position stored in memory.

3. Press buttons (A), (B) and (C) simultaneously and then release.

• All segments of the digital display are shown when either of the buttons is

released.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30

Pas de commentaire

Citizen C390 Spécifications Page 24