Citizen CT 253C Manuel d'utilisateur télécharger pdf (Page 26)

2 Preparation

2-7-2. Example Settings

 Use the WPS function and Configure Settings*

1) Connect the Wireless LAN adapter to the IF1-WF01.

2) Turn on the printer.

Confirm that the IF1-WF01 recognized the Wireless LAN adapter. The Wireless LAN adapter is

recognized approximately 20 seconds after the printer is turned on. The status indicator LED

(green) starts flashing.

3) Hold the WPS button on the Wireless LAN adapter for 1 second or more. The LED on the

Wireless LAN adapter starts flashing.

If the adapter cover is being used, either open the cover or use a thin needle to press the WPS

button from the hole in the cover.

4) Start the WPS function of the access point.

5) When the configuration is complete, the LED of the wireless LAN adapter changes to

transmission status.

You can confirm that the configuration was performed correctly by pressing the panel button to

print out the configuration of the IF1-WF01. See 2-5, Printing the Wireless LAN Interface Board

Configuration (page 21) for details.

* For the method to start the WPS function, see the manual of the access point. If the access point

you are using does not support the WPS function, perform configuration by using the

“

Configuring using the Wired LAN Adapter” method.

 Configuring using the Wired LAN Adapter

1) Connect the Wireless LAN adapter to the IF1-WF01.

2) Connect the wired LAN cable to the IF1-WF01.

3) Turn on the printer.

After the printer is turned on and the IF1-WF01 starts, the IF1-WF01 will automatically obtain an

IP address from the DHCP server within 90 seconds. If an IP address cannot be obtained

automatically, use the ZeroConf function to allocate the IP address 169.254.XX.YY (XX.YY will

differ by a setup environment). Allocate the IP address while referring to 4-3, Setup Window

(page 47).

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 48 49

Pas de commentaire

Citizen CT 253C Manuel d'utilisateur Page 26